mobileye mips socs · Maintained

Maintainers

• M Vladimir Kondratiev <vladimir.kondratiev@mobileye.com>
• M Benoît Monin <benoit.monin@bootlin.com>
• M Gregory CLEMENT <gregory.clement@bootlin.com>
• M Théo Lebrun <theo.lebrun@bootlin.com>

Paths

• F Documentation/devicetree/bindings/mips/mobileye.yaml
• F Documentation/devicetree/bindings/soc/mobileye/
• F arch/mips/boot/dts/mobileye/
• F arch/mips/configs/eyeq*_defconfig
• F arch/mips/mobileye/board-epm5.its.S
• F drivers/clk/clk-eyeq.c
• F drivers/phy/phy-eyeq5-eth.c
• F drivers/pinctrl/pinctrl-eyeq5.c
• F drivers/reset/reset-eyeq.c
• F include/dt-bindings/clock/mobileye,eyeq5-clk.h
• F include/dt-bindings/clock/mobileye,eyeq6lplus-clk.h

Last 30 days

Recent patches

Most-recent 19 patches in this subsystem on linux-arm-kernel, ordered by date desc.

• STALE390d REVIEWED: 8 (8M) [PATCH 2/4] reset: eyeq: drop device_set_of_node_from_dev() done by parent
  2025-06-11 · Jerome Brunet <jbrunet@baylibre.com>
• STALE390d [PATCH 1/4] clk: eyeq: use the auxiliary device creation helper
  2025-06-11 · Jerome Brunet <jbrunet@baylibre.com>
• STALE508d [PATCH v4 6/8] reset: eyeq: drop device_set_of_node_from_dev() done by parent
  2025-02-18 · Jerome Brunet <jbrunet@baylibre.com>
• STALE508d [PATCH v4 5/8] clk: eyeq: use the auxiliary device creation helper
  2025-02-18 · Jerome Brunet <jbrunet@baylibre.com>
• STALE519d [PATCH] reset: eyeq: drop device_set_of_node_from_dev() done by parent
  2025-02-12 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE519d [PATCH v3 5/7] clk: eyeq: use the auxiliary device creation helper
  2025-02-11 · Jerome Brunet <jbrunet@baylibre.com>
• STALE859d REVIEWED: 1 (0M) [PATCH v3 11/11] MIPS: mobileye: eyeq5: add evaluation board I2C temp sensor
  2024-03-06 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE859d REVIEWED: 1 (0M) [PATCH v3 10/11] MIPS: mobileye: eyeq5: add 5 I2C controller nodes
  2024-03-06 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE864d [PATCH v2 10/11] MIPS: mobileye: eyeq5: add 5 I2C controller nodes
  2024-02-29 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE864d [PATCH v2 11/11] MIPS: mobileye: eyeq5: add evaluation board I2C temp sensor
  2024-02-29 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE870d [PATCH v2 29/30] MIPS: mobileye: eyeq5: add resets to GPIO banks
  2024-02-28 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE870d [PATCH v2 30/30] MIPS: mobileye: eyeq5: map GPIOs to pins using gpio-ranges
  2024-02-28 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE870d [PATCH v2 28/30] MIPS: mobileye: eyeq5: add two GPIO bank nodes
  2024-02-28 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE870d [PATCH 13/13] MIPS: mobileye: eyeq5: add resets to I2C controllers
  2024-02-15 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE870d [PATCH 12/13] MIPS: mobileye: eyeq5: add evaluation board I2C temp sensor
  2024-02-15 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE870d [PATCH 11/13] MIPS: mobileye: eyeq5: add 5 I2C controller nodes
  2024-02-15 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE877d [PATCH 23/23] MIPS: mobileye: eyeq5: map GPIOs to pins using gpio-ranges
  2024-02-14 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE877d [PATCH 22/23] MIPS: mobileye: eyeq5: add resets to GPIO banks
  2024-02-14 · Théo Lebrun <theo.lebrun@bootlin.com>
• STALE877d [PATCH 21/23] MIPS: mobileye: eyeq5: add two GPIO bank nodes
  2024-02-14 · Théo Lebrun <theo.lebrun@bootlin.com>